P a g e
|
12
DSEFO146-12 Rev 10/20
FIGURE 6.
Before moving on to the following step, apply a small amount of the supplied Anti-Seize
Compound to the threads of the U-Bolts to prevent galling:
11)
Attach the boom to mast plate to the boom midway between elements D-5 and D-6.
Use the ¼” U-bolts with flat washers, lock washers and nuts. The antenna will be front heavy
at this point but the weight of the feedline, when attached, will cause it to be balanced. If using
multiple antennas in an array, be certain all mounting plates are at the same location. When
attaching the antenna to your mast, use the 5/16” U-Bolts, flat washers, lock washers and
nuts.
Once you have the U-bolts installed and the antenna mounted on your support mast and
tightened, you can route your feedline along the mast and over to the driven element and
connector. Dress the coax against the antenna boom and tighten the connector. Seal the
connector body with several layers of good grade vinyl tape. Then apply a layer of butyl rubber
antenna sealer or RTV over the tape. This will provide a good vapor barrier and ensure years
of trouble free performance. The insulated design will make for a very long-lived antenna that
will stand up well in harsh environments.
Содержание DSEFO146-12
Страница 5: ...P a g e 5 DSEFO146 12 Rev 10 20 FIGURE 4 ...
Страница 6: ...P a g e 6 DSEFO146 12 Rev 10 20 ...
Страница 9: ...P a g e 9 DSEFO146 12 Rev 10 20 170mm ...
Страница 10: ...P a g e 10 DSEFO146 12 Rev 10 20 180mm ...
