19
933.TL2 4.12.193.2 2015 Toyota Sienna (Smart Key)
© 2021-02-19 Directed. All rights reserved.
Soft reset
A module reset will only erase the steps perfomed in “Module Programming”. The firmware and settings flashed to the module will
not be affected.
1
If required for your installation,
connect
all the harnesses to the module,
EXCEPT
the 12-pin
main power harness.
Press
and
hold
the programming button, then
connect
the 12-pin
harness to the module.
Connect all but the
12-pin harness
2
DS3+: Wait
3 seconds until the LED turns ON solid orange then
release
the programming
button. The LED turns ON solid red.
&
&
Solid
Solid
Release
DS4+: Wait
3 seconds until the LED turns ON solid orange then
release
the
programming button. The LED turns ON blue for 1 second then solid red.
&
&
&
Solid
Solid
Release
Solid
x1 Sec
Hard reset
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default factory settings. Depending on the installation, some settings
may need to be reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable
features.
1
If required for your installation,
connect
all the harnesses to the module,
EXCEPT
the 12-pin
main power harness.
Press
and
hold
the programming button, then
connect
the 12-pin
harness to the module.
Connect all but the
12-pin harness
2
After 3 seconds the LED turns ON solid orange.
Keep holding
the programming button until
the LED flashes red, then orange slowly.
Solid
Flashes
&
&
Hold
3
DS3+
:
Release
the programming button. The LED turns solid red.
&
Solid
Release
DS4+:
Release
the programming button. The LED turns ON blue for 1 second then solid
red.
&
&
Solid
Release
Solid
x1 Sec
