Rev.: 20
914
170
Platform: DBALL2
Firmware TL7
:
© 2017 Directed. All rights reserved.
Module Programming
Refer to the LED Diagnostics section on page
for more information and for troubleshooting purposes.
s 24-25
The master key
module programming
.
is
to complete the
successfully
REQUIRED
3
2
Insert
turn
and
the key to the ignition position. The
turns
solid
LED
ON
green for 3 seconds. This may take up to
.
5 seconds
Turn
the
the
key to
position.
OFF
&
Key IN
OFF
START
IGN
Page 22
Key OUT
OFF
START
IGN
1
Solid
Wait until the LED turns
solid red.
ON
Note:
To skip the transponder programming and use convenience features only,
press
the
5 times.
programming button
You have successfully completed the module programming sequence.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use Xpress
4.5 (and higher) or the Directechs Mobile app.
VIP
When the flashing operation is successful, you can proceed with the programming instructions below.
OR
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
D2D Installation
W W Installation
2
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
10-pin
D2D
1
st
12-pin
14-pin
2
nd
3
rd
10-pin
D2D
1
st
4
th
12-pin
14-pin
2
nd
3
rd
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the
button.
Flash Module
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH
button.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your
oader3.
XKL
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select
and follow the on screen
FLASH YOUR MODULE
instructions.
Green
3 seconds
Note:
If the transponder programming was skipped, the
turns
LED
ON
solid orange for 3 seconds then shuts
when programming is done.
OFF