P.4
User Guide
Vehicle Presets
Heater
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, should not be left on
HIGH
. It
is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers, Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain
types of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in
a dead battery.
Using the Transmitter
Your remote starter is equipped with a 6-button multi-channel remote control. It can operate two
independent vehicles equipped with identical remote starters (see
Multi-car operation
section on
page 17)
The functions of the 2-way transmitter are as follows:
LOCK:
Locks the doors and arms the STARTER KILL (if installed).
UNLOCK:
Unlocks the doors and disarms the STARTER KILL (if
installed). Activates the AUX 1 output if Priority Door Access is
configured.
TRUNK:
Opens the
TRUNK
or activates the
AUX 3
output.
Note:
Trunk option must be installed.
START
:
Remote starts the engine. Gets the system into Cold Weather
mode if pressed for longer than 3 seconds.
Note:
Icon may vary.
FUNCTION button
Turns the backlight
ON
, allows access to the Multi-level
functions and to the Menu.
AUX button (if programmed):
Activates
AUX 2
output, stops the engine, requests
Temperature, activates Panic mode or activates Cold Weather
mode.