Directed Electronics Valet 9405T, Руководство пользователя, Страница: 6 / 9

1. Verify that the size of the supplied hole saw
is compatible to the diameter of the sensor
before drilling your bumper. Use a scrap piece
of wood for this test.
N No ottee:: Before drilling any holes in the vehicle ensure
that the the area behind is clear of any electrical,
hydraulic, or support members, etc.
2. Install the sensor vertically, the "up" arrow
must be pointing up.
3. Each sensor is numbered, ensure that they are
installed as shown on the illustration.0
0.3L 0.4L 0.3L
5 ~8 inches 5 ~8 inches
1 foot 8 inches
~2 feet 3
inches
SSeennssoorr IInnssttaallllaattiioonn
6 6
© 2005 Directed Electronics, all rights reserved
N9405T 11-05
IInnssttaallllaattiioonn
N No ottee:: Before installing system let the
components of the exhaust system cool
down. This will make the installation safer
and preclude heat damage to the back up
sensor wiring or components.
The following illustration shows the general loca-
tion of the components of the back up system.
IInnssttaallllaattiioonn DDiiaaggrraam m
Display
Connect to
ignition wire (+)
Connect to
reversing light(+)
ECM
Sensors