+12V
GND
Fuse
D2D (4 pin, wht)
ESP (3 pin, blk)
ESP (4 pin, brn)
2 pin
4 pin
+12V
GND
D2D
(4 pin, white)
2 pin
4 pin
cut loop (see table)
✂
CPU1
NOTE: The appearance and connector/port arrangement on the
Directed/Avital/Xpresskit system may differ to the examples shown .
SmartStart Module
(Top view)
SmartStart Module to Xpresskit
Directed System
(Top view)
LED
+12V
GND
Fuse
D2D (4 pin, wht)
ESP (3 pin, blk)
ESP (4 pin, brn)
2 pin
4 pin
+12V
GND
D2D
(4 pin, white)
2 pin
4 pin
cut loop (see table)
✂
CPU1
NOTE: The appearance and connector/port arrangement on the
Directed/Avital/Xpresskit system may differ to the examples shown .
SmartStart Module
(Top view)
SmartStart Module to Xpresskit
Directed System
(Top view)
LED
Installation Procedure
This product is compatible with all Directed Electron-
ics Security, Remote Start and hybrid systems that are
Bitwriter™ (3 or 4 pin) compatible:
CAUTIONS:
Cable connectors and their
associated ports are the same color. Con-
necting to the wrong port can damage
the unit.
DO NOT
connect the white 4-pin D2D
connector to brown ESP port on Directed
systems.
DO NOT
connect the black 3-pin ESP con-
nector to white Door Lock port on Direct-
ed systems.
The white connector cannot be connected
to Xpresskit module except in standalone
Datastart applications as shown below.
For all ESP systems, connect Xpresskit
module to the Directed system,
not
to the
SmartStart Y-adapter.
Please read the following before proceeding
1.
Customer Information required:
• Record the customer information requested
in step 5a of this procedure. The module ID
# is provided on a sticker which can be af-
fixed to the space provided in step 5a.
• Is this a new account or one being added to
an existing account? Check box(es) in 5a.
This information is required for final verification/
activation of the VSM200/DSM200.
2.
Installation Points:
• Install and test the security/remote start sys-
tem first using the associated guides and
wiring diagram. If using an existing system,
verify it is fully functional before installing the
Directed SmartStart module.
• For 3000-series Remote Start systems with
no supplied remote control, test the installed
system using the functional commands in the
SmartStart activation portal.
• Mount the SmartStart module as high as pos-
sible in the vehicle (side with color label up).
Mount with minimal obstructions that can
affect communications and within reach of
the main Directed system using the provided
cables (do not extend).
• DO NOT connect the SmartStart module un-
til the final programming of the Remote Start
main unit and verification of security/remote
start system operations are completed.
3. Install the VSM200/DSM200 using the informa-
QRNDSM200 2010-08
White
Brown*
Communication Type
Closed
Closed
2-way ESP
Closed
Open **
2-way D2D
* This wire color may be blue on some units.
**
If a loop is cut, the module must be powered off
and then on again to initiate this state change.
Quick Reference
Install Guide
VSM200/DSM200
