Directed Electronics Python 880XP, Руководство по установке

Страница: 13 / 44

© 2002
Directed Electronics, Inc.
13
H2/2 LIGHT GREEN/BLACK (-) Factory Disarm Output
This wire sends a negative pulse every time the remote start is activated or the alarm is disarmed.
This can be used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a relay to
send a (-) or (+) pulse to the disarm wire as shown in the diagrams below. This wire can also be used
as a special accessory output. (See
Feature Descriptions section of this guide.)
R Reellaayy ffoorr N Neeggaattiivvee ((--)) D Diissaarrm m W Wiirree R Reellaayy ffoorr PPoossiittiivvee ((++)) D Diissaarrm m W Wiirree
H2/3 VIOLET/BLACK 200 mA (-) Channel 4 Output
This wire provides a (-) 200mA output whenever the transmitter button(s) controlling Channel 4
is pressed. This output can be programmed to provide the following types of outputs. (See the
Feature Menus section.)
➤
Validity: Output that will send a signal as long as the transmission is received.
➤
Latched: Output that will send a signal when the Channel 4 button(s) is pressed and will
continue until the same button(s) is pressed again.
➤
Latched, reset with ignition: Similar to the latched output, this type of output turns on the first
time the Channel 4 button(s) is pressed and turns off the next time the same button is pressed.
This type of output additionally stops and resets whenever the ignition is turned on and then off.
➤
30-second timed: Output that will send a continuous signal for 30 seconds.
➤
Second unlock output: This output can also be programmed to provide a second unlock pulse
whenever the disarm button is pressed within 15 seconds after disarming the system. This setting
could be used to unlock the passenger doors when installing progressive door locks, for instance.