22
manual programming instructions
It is a good idea to document changes by taking note of all feature
changes made in programming mode.
To enter the User Selectable Features programming:
1.
Ignition on - Turn the ignition to the run position or start the
engine.
2.
Enter PIN - Enter the factory preset PIN code.
3.
Hold/Chirp/Release - After entering the PIN code, press and
hold
until a chirp is heard and the LED turns on, then
release the button. You have now entered the feature selec-
tion position of the User Selectable Features grid.
4.
Column select - Press
the same number of times as the
desired column. After a pause the siren will chirp the same
number of times as the selected column for confirmation.
5.
Feature select - Press
the same number of times as the
desired feature. The siren will chirp with each press. The fea-
ture can now be changed using the remote control.
6.
Feature change - Press
on the transmitter. If the sys-
tem chirps once, the feature has just turned off; if the sys-
tem chips twice, the feature has just turned on. If the fea-
ture has more than two settings, continue pressing
on the transmitter to toggle through the settings.
You can advance to any feature in the same column by
pressing
within 60 seconds; to program a feature in a
different column begin at step 4 within 60 seconds.
nnoottee:: If the factory preset PIN has been changed, the new PIN must be
entered.
