5
403.HYUNDAI10 2.11 2020 Hyundai Santa Fe (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in pricing
accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Keys
required for
programming
1
Keys required
for operation
0
Important!
Firmware Version 2.00 and higher use different input/output configurations and are
NOT
compatible with the wiring
instructions of previous versions. Updating an older version to version 2.00 or higher will require wiring modifications.
Note:
Damage to the vehicle may occur if the appropriate wiring modifications are not done.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Refer to the "Vehicle connections" following the installation diagram.
General notes:
This section highlights important information for this specific firmware.
[1]
The installation of an aftermarket hood pin is
ONLY
required on vehicles that are
NOT
equipped with a factory hood pin or if
NOT
supported in data.
[2]
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[3]
The resistor value is approximately 4.2K.
[4]
Connection is optional. Connecting the PTS wires will result in a "Get it and Go" takeover procedure for the client. If
NOT
connected, the
client needs to push the PTS button for Takeover and Pit Stop mode.
IMPORTANT
: In the "Quick Reference Guide" section, you
MUST
check off the box that corresponds with the installation.
[5]
Connection required if power lift gate is desired during runtime.