Direct IP IDIS DP-DE2108, Руководство по эксплуатации

Страница: 12 / 36

Part 1 – Introduction
12
3
Factory Reset Switch
Used to return all settings to the original factory settings. Connect the power and poke a straightened paperclip
into the factory reset switch hole. Hold the reset switch until the encoder’s front power led blinks. Release the reset
switch, and all of the encoder’s settings are now at the original settings it had when it left the factory.
•
Factory Reset during system booting
: All of the encoder’s settings are now at the original settings it had when
it left the factory.
• Factory Reset during system operating : The other settings except for protocol and system log are now at the
original settings it had when it left the factory.
•
Factory Reset via the IDIS Discovery program
: The other settings except for protocol, system log and network
settings are now at the original settings it had when it left the factory.
•
Factory Reset via the IDIS Discovery program(including network settings)
: The other settings except for
protocol and system log are now at the original settings it had when it left the factory.
Rear Panel
1
2
3 4
1
Audio In
2
Video In
3
N PoE Power In
4
DC12V In
1
Audio In
Connect to an audio source.
2
Video In
Connect coaxial cables from the video sources.
3
N PoE Power In
Connect a Cat5e cable with an RJ-45 jack. The video encoder is capable of connecting to networks via an Ethernet
connector and also receives PoE power from the NVR. When the network link is established, the orange LED on the
left blinks. When a 1000 BASE-T link is established, the green LED on the right is lit.