Direct IP IDIS DC-T4537HRXA, Руководство по эксплуатации

Страница: 20 / 49

Part 1 - Remote Setup
20
• Intelligent Codec: Analyze real-time video
intelligently to minimize bitrate while maintaining
frame rate and image quality.
In environments where there are many video changes,
image quality can be reduced.
• Multi-View Streaming : Designate a specific area of
the screen and stream images from that area only.
(not supported for the primary stream) Click
Setup
to
designate a streaming area.
Select
On
and then specify the streaming area’s
resolution.
- Resolution Limit : Indicates the maximum
resolution that can be set for the streaming area.
-
Resolution
: Designate a streaming area.
Designated area is marked in red on the screen. You
can adjust the resolution of the area or reposition
the area by dragging and dropping using the
mouse.
- Current Resolution : Displays the resolution of the
designated streaming area.
If multiple users are connected to the camera, the
increase in bandwidth use can lower the frame rate.
MAT
Select the
MAT
option to use the MAT (Motion Adaptive
Transmission) feature during video transmission and
recording.
•
Sensitivity
: Set the motion detection sensitivity.
Higher values will result in more sensitive motion
detection.
•
Inactivity Period
: Set the Inactivity Period. If motion
is not detected for the duration of time specified,
video is transmitted and recorded using the frame
rate designated below until movement is detected
again.
• Frame Rate : Designate the frame rate to be used
between the end of the Inactivity Period and the next
motion detection. When the slow shutter mode is
enabled under
Video > Camera menu, the fame rate
may change. Video is transmitted and recorded at
the designated frame rate between then end of the
Inactivity Period and the next motion detection. Once
motion is detected again, the frame rate designated
under
Streaming is restored immediately.
MAT (Motion Adaptive Transmission) is a feature
that lowers the frame rate when motion is not
detected to reduce the load on the network and save
on storage space. Based on the specified sensitivity
setting, no movement will be assumed if there is no
change between two consecutive images.
MAT function does not work during the Smart
Failover
recording.