Direct IP Idis DC-S Series, Руководство по установке

Страница: 11 / 21

Part 1 – Introduction
11
When inserting an alarm in/out, audio in/out,
or video out, connector, hold down the button
and push the connector in through the exposed
hole. Release the button and then gently pull
on the wire to ensure a secure connection. To
disconnect, press down on the button again and
pull the wire out.
• Check your local laws and regulations on
making video or audio recordings. The user will
be held liable for any violation of the law.
• Organize the power cable so that it will not
cause people to trip over or become damaged
from chairs, cabinets, desks, and other objects
in the vicinity. Do not run the power cable
underneath carpet or a rug or plug the cable
into a power outlet shared by a number of other
devices.
• Wrap the camera-end of the earth cable twice
around the provided ferrite core for EMC
(Electromagnetic Compatibility). If not, you may
experience video stuttering.
Ferrite Core
Network Cable
• The network connector is not designed to be
connected directly with cable or wire intended
for outdoor use.
Factory Reset
Only use the factory reset button to restore the camera
to its factory default settings.
A factory reset will clear all camera settings configured
by the user.
1
Shut off the power supply.
2
Press and hold the reset button down.
3
Hold the button down and reconnect the power.
4
Once the device turns back on, wait 5 seconds, and
then release the reset button.
5
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
It's also possible to do a factory reset by pressing and releasing
the reset switch while the camera is turned on or using the IDIS
Discovery program from a remote location. A factory reset will
reboot the system. For more information on factory reset, refer
to the
IDIS Discovery operation manual .
Make sure that the cover is joined properly when
screwing it; otherwise, the IP66 level is not guaranteed.