Page | 3
©Direct Connection RC
Pre
–
Build
1.
Align each set of the trailing edge pieces on a flat surface along a long straight edge. Glue
together each of the trailing edge sets at the zig-zag joint using your preferred glue (CA). Allow
to set. This will leave you with a top and bottom piece for the trailing edge. Set aside.
2.
Lay the two main spar pieces flat, aligning along a straight edge. Recommended keeping the slot
end up and using small weights to keep the spar as flat as possible. Glue together the two main
spar pieces at the zig-zag joint using your preferred glue (CA); allow to set. Set aside.
