8
Blow through one of the lines to ensure
the fuel lines have not become kinked inside
the fuel tank compartment. Air should flow
through easily.
1) Install the pushrod housing through the
predrilled hole in the firewall and into the
servo compartment. The pushrod housing
should protrude 1/4” out past the front of the
firewall. Make a Z-Bend 1/4” from one end
of the plain wire pushrod.
2) Place your engine onto the engine mount.
Adjust the engine is centered of the adges of
the engine case.
4) Remove the engine. Using an drill bit,
drill the mounting holes through the engine
mount at the four location marked.
5) Bolt the engine to the engine mount using
the four machine screws. Double check that
all the screws are tight before proceeding.
6) Attach the Z-Bend in the pushrod wire to
the throttle arm on the carburetor.
3) When you are satisfied with the alignment,
mark the location of the engine mounting.
MOUNTING THE ENGINE.
Vent tube.
Fuel pick up tube.
Fuel fill tube.
C/A glue.
150mm
4.2mm diameter.
Fuel tank.
