3
To prevent damage to the coating cover
your workbench with a cloth or blanket.
Do not pull on the packaging you may be
too much pressure and break your plane.
Carefully unpack the wings and fuselage us-
ing scissors or a craft knife. Open aware of
hardware apart and sort all parts in order to
understand who goes where. Store in a se-
ries of independent small boxes. When you
work, do not let scews, miscellaneous hard-
ware, accessories and tools below different
parts of your aircraft. Check constantly. Be-
fore gluing carefully prepare all the parts,
try them and if needed dig slots a bit more.
Work slowly and read many time techni-
cal instructions to be sure to understand all
tricks.Repeat gestures before using glue. If
overflows
do not use acetone
on coatings
and plastics. Often simply wipe with a paper
towel.
To ensure the mobility of flaps we planned
cylindrical hinges. The trick is that these
hinges are installed at 90°mean 45°on each
side. See photos. That way when you leave
the flaps deport these hinges and shutters
create a slot effect that brings the lift in ad-
dition to limiting the braking effect of tur-
bulence flaps and thus repel the stall speed.
All hinges are pre-installed but not glued.
Before removal for sizing carefully locate all
positions with a ballpoint pen not to create a
gap for the collage.Note the middle hinge so
that the same amount is depressed in both
parties. Plant may also serves as a needle
stop which provides the necessary play and
flexibility. If you use the cyano coat once all
the hinges with a veil of cyano.
Drill your 45° holes about 2mm before the
edge. Be careful not to cross!
Cut hinges
taking into account the thickness of the
wing. Introduce all hinges. The hinges must
be pressed closer, gently so that the offset is
reasonable. To check the alignment of the 3
hinges use simply your eye. If you need to
reduce the offset just push a bit more. Flaps
are manipulated to test the flexibility of op-
eration. Monitoring the orientation of the
hinge pins to be perpendicular to the rota-
tional movement.
HINGING THE FLAPS.
INSTALLING HINGES GENERAL.
TIPS FOR ASSEMBLY
