DIP DS-68, Руководство пользователя, Страница: 9 / 27

DS-68 - Operating manual
9 Phone: +40 21 345 11 06 • Fax: +40 21 345 11 07
Hopper:
Wash the hopper once it has been removed from the appliance, using neutral soap
and water, rinse abundantly with warm water and dry thoroughly. It is recommend
to clean the hopper periodically.
Grinding Disk Replacement:
In order to change the grinding disks of the DS-68 please follow the steps found
below:
• Close the
Hopper locking slide
(fig.1).
• Start the machine until you stop hearing the sound of coffee beans grinded.
¢
Unplug the machine.
• Remove the hoper and check that no coffee leftovers are found in the grinding
chamber.
• By keeping the
Indexing mechanism
pressed at all times, turn the
Coffee
grinding adjustment disk
(fig.1) anti-clockwise until it is fully released.
• Unscrew the lower disk found in the grinding chamber and the upper disk
found on the
Coffee grinding adjustment disk
.
• Clean thoroughly the surface where both disks were rested.
•
Att:
The grinding discs are not the same:
Place the disk with less channels to the lower position (motor side).
Place the disk with more channels to the upper position (Coffee
grinding adjustment disk)
• Place the new grinding disks in the above described position and fasten
them tightly with their screws.
• By keeping the
Indexing mechanism
pressed at all times, turn the
Coffee
grinding adjustment disk
(fig.1) clockwise until it is tightly fastened.
• Check that the Coffee grinding adjustment disk indicator (fig.1) is close to O.
• By keeping the
Indexing mechanism
pressed, turn the
Coffee grinding
adjustment disk
(fig.1) anti-clock wise, until its indicator is indexed to 1.
¢
Connect the machine to the mains.
¢
Set the working mode to Manual (chapter 8).
• Start the machine by pressing the start micro switch (fig. 1),
JUST ONCE
. If
you hear the sound of metal scraping turn the
Coffee grinding adjustment
disk
(fig.1) anti-clock wise until its indicator is indexed to 2.
• Start the machine again by pressing the start micro switch (fig.1),
JUST ONCE
to make sure that you do not hear any sound of metal scraping.
• Set the working mode to your preference.
Auto
,
Auto Plus
or
Manual
(page 17).
• Adjust the grinding fineness at the optimal setting (fig. 2).