DIP DS-68, Руководство пользователя, Страница: 8 / 27

8
DS-68 - Operating manual
www.dipgrinders.ro • office@dipgrinders.ro
Safety protection:
THERMAL OVERLOAD PROTECTION
The appliance’s motor is protected against overheating by a thermal protection
which, when tripped, cuts off the motor’s power supply. If the protection trips as a
result of anomalous operation, such as jamming the grinding blades, the appliance
must be turned off using the ON/OFF switch (fig.1), DISCONNECTED FROM THE
MAINS, AND CONTACT A LICENSED TECHNICIAN.
Noise level:
The maximum noise emission of this coffee grinder is measured in UNI EN ISO 3741
reverberating chamber in compliance with the EN 60704-1 regulations and complies
with the EN 60704-1:1998 and EN 607043:1996 regulations.
The daily noise exposure of a worker, due only to an appliance’s limited operation of
240 minutes per 8 hours, is 78 dB (A), according to ED 89/188/ECC and ED 200311/
EEC. Therefore, during the daily operation, measures must be taken in order to
prevent any injury from noise exposure (article 3-8 of ED 2003/10/EEC).
Maintenance:
It is essential to check the status of the cable and plug periodically.
IN THE EVENT OF DAMAGED SUPPLY CABLE OR PLUG, CALL IN A LICENSED
TECHNICIAN TO REPLACE THEM. THIS WILL PREVENT ANY FUTURE DAMAGE OF THE
APPLIANCE.
It is recommended to use original replacement parts to assure the proper
working conditions of the appliance. A licensed technician must perform periodic
maintenance, including detailed inspection of those components subject to wear.
The status of the grinding blades must be checked periodically. Keeping them in an
excellent condition, assures better productivity and cooler coffee outcome.
Cleaning the appliance:
THE APPLIANCE CANNOT BE CLEANED USING WATER JETS.
THOROUGH CLEANING MUST BE PERFORMED PERIODICALLY BY A LICENSED
TECHNICIAN.
Use perfectly clean, disinfected cloths or brushes for cleaning.
Do not use abrasive products for cleaning in order to prevent damaging the shiny
parts.
NEVER PERFORM ANY MAINTENACE OR CLEANING OF THE APPLIANCE
WHILE IT IS CONNECTED TO THE MAINS