Dionex ASE 150, Руководство оператора

Страница: 24 / 176

ASE 150 Operator’s Manual
16
Doc. 065207-02 9/08
•
The drain directs solvent spills from the bottle area on top of the ASE 150 to
the rear panel. A drain hose connects to the fitting. For installation
instructions, see
Section B.2.2 .
2.3 ASE 150 Extraction Process
Preparing to Run an Extraction
The following steps are required before the ASE 150 can perform an extraction.
Refer to
Chapter 3 for detailed instructions for each step.
•
Fill the solvent reservoir.
•
Prepare the sample and load it into the sample cell.
•
Install the waste bottle and collection vessel.
•
Select or create a method.
•
Press the
START
button.
•
Verify that the
STATUS
on the
STATUS
screen is
OVEN READY
(see Figure 2-5 )
and the LED on the
START
button is flashing.
•
Install the sample cell in the cell holder and close the cell door.
•
Press the
START
button.