Dion F67, Руководство оператора, Страница: 30 / 38

30
F6715E968
ADJUSTMENTS - MAINTENANCE
DISK CLEANER ADJUSTMENT - FIGURE 40
To prevent debris accumulation and material jam,
regularly check and adjust the disk cleaning forks
located on the lateral fingers. Adjust so that the gap
between the tip of the teeth and the cleaner is kept at
1/4” (6 mm) or less but without ever touching the
disk.
Figure 40 Disk cleaners
KNIFE SECTION REPLACEMENT
FIGURES 41 AND 42
Each knife is made of 4 sections. Each section can
be replaced individually. These sections are made
from tempered steel for extended life. In case of
failure or premature wear, they can be replaced as
described below.
1. Remove the four bolts holding the knife section.
2. Remove the reinforcement plates under the
disk.
3. Replace the section then install the reinforce-
ment plates back under the disk with the four
bolts supplied with the knife.
4. Tighten all bolts back.
1
Figure 41 Removing the four bolts
Figure 42 Replacing a knife section