3 OF 3
®
Toll Free: 877.817.6028 | Fax: 415.592.1596 | www.DiodeLED.com | [email protected]
© 2019 Elemental LED, Inc. All rights reserved. Specifications are subject to change without notice.
IG070319-2.0
TOUCHDIAL
™
Mini Remote RGB(W) Control INSTALL GUIDE
TOUCHDIAL
™
Mini Remote Dimmer
INSTALLATION GUIDE
Symptom
Common Cause
Control won’t
function
• Check for dead batteries.
• Remote must be turned on for
operation.
Master receiver does
not sync with remote
• Ensure function is set to MASTER
(1 pin) - See Syncing Note or
TOUCHDIAL Receiver Installation
Guide.
• If still not syncing do following: 1)
Turn off main power to receiver and
turn back on. 2) Reset receiver by
long pressing LEARNING KEY for
5 seconds until LED flashes. 3) Re-
sync receiver to control.
TROUBLESHOOTING
See TOUCHDIAL Receiver Install Guide for more troubleshooting tips.
BATTERY REPLACEMENT
1. Open Battery backplate on Remote.
2. Insert new battery.
TOUCHDIAL MINI REMOTE RGB(W) CONTROL
SPEC SHEET
F
or full specifications.
TOUCHDIAL RECEIVER SPEC SHEET & INSTALL
GUIDE
F
or full specifications and installation instructions.
ADDITIONAL RESOURCES
CR2430
Batter
y
MOUNTING
Me
tal Moun
ting Pla
te
RGB
W
1. Place Metal Mounting Plate on surface where desired, using
included 3M Mounting Tape Pad.
2. Place Mini Remote onto Mounting Plate. The Magnet inside
Mini Remote will hold it in place.
