www.getdio.com
EN | 10
The motor does not work even though
it is powered on.
1) A thermal protection device may be activated. In
this case, wait for about 20 minutes for the motor to
cool down.
2) Check that the network voltage matches the
specifications listed on the product label.
3) Check that the end stop settings do not overlap.
If this is the case, turn each adjustment screw a few
turns anti-clockwise and adjust the end stops again
(see IV. Adjusting the end stops).
I cannot control my motor remotely.
1) Check that the radio antenna is not damaged and
that it is coming out of its housing properly.
2) Check the motor connections
3) The transmission distance between the remote
control and the radio antenna of the motor is about
50 metres. This distance may be reduced by an
existing wireless environment or by the thickness of
the walls. If necessary, add a transmission relay (Ref
54799) to increase the distance.
Troubleshooting
HomeBox
LiteBox
DINING ROOM
Partial opening of the shutter
Press the ON ('I') button on the remote
control to start opening the shutter. Press the
same button again to stop the shutter at the
required position.
Add control points
You can add DiO 1.0 accessories to control
your shutter with other control units (switch,
remote control, smartphone, etc.; maximum 12
control units) - see III.4. Installing the remote
control unit.
Control and programme all your devices using
your smartphone
With the Dio HomeBox or LiteBox, you can
control your shutters using your smartphone,
control of your control units centrally,
programme opening and/or closing times and
create life scenarios.
