2 Installation
SBC300 Session Border Controller
Copyright©2011-2018 Dinstar
8
Hub, telephone set, fax, and small PBX
Terminal (can be a PC which is equipped with hyperterminal simulation software)
Unpacking
Open the packing container to check whether the SBC300 device and all accessories have been in it:
One SBC300 device
One power adapter: 12V, 2A
Two network cables
One Serial console cable
Screws
2.2
Installtion of SBC300
Put SBC300 into Shelf
1.
Put the SBC300 device on the shelf or cabinet horizontally;
Connect SBC300 to Network
SBC300 has five network ports, namely the gigabit network port for services (from GE0 to GE3) and the gigabit
network port for network management (Admin). It is advised to connect GE0, GE1, GE2 or GE3 to the IP
network.
Both GE0/GE1/GE2/GE3 and Admin can be used to carry out management on SBC300, but generally
GE0/GE1/GE2/GE3 are put in use. Admin is used when there is a need to separate management-related processing
from service processing on SBC300.
How to make RJ45 Network Cable
Step1.
Prepare a twisted-pair cable with a length of at least 0.6 meters, and then remove the shuck of the network
cable;
Step2.
Sequence the wires of the cable according to EIA
／
TIA 568B Standard (as shown in the following figure);
