Dinolift DINO XT II 160, Руководство по эксплуатации

Страница: 42 / 73

42
Operating instructions • DINO 160XTB II • 180XTB II • 210XTB II
5.1.4. Supporting the lift
1. Turn the selector switch Q1 to the position LCB – chassis control
centre.
Piirustuksen numero
VILAKONE OY
Tulostus pvm.
Revisio
Kpl/kone
Ohjetarra, joystick
1
41603606
2. To activate the support outriggers, depress start button for the
outriggers. The button must be kept depressed throughout the
operation.
3. Lower the front support outriggers 1-2 (on the tow-bar side).
4. Lower the rear support outriggers 3-4. Be careful not to bang the
tow-bar jockey wheel against the ground.
5. Level the chassis with the outriggers with the help of the level
gauge. The air bubble must be located inside the inner ring.
6. The signal light (green) in the chassis control centre is illuminated,
when all the outriggers are in the support position and the limit
switch circuit for the outriggers is closed.
1 2
3 4
Supporting the lift using the automatic levelling function (option)
1. Lower the outriggers from the DCB control centre via the lever switch.
The automatic levelling function positions the outriggers on the ground
and levels the chassis.
1 2
3 4
2. Keep the lever turned until the signal light above the switch stops
flashing. If you release the lever, the operation will be interrupted and
the light will go out. The levelling can be resumed by turning the lever
anew.
1 2
3 4
3. If the signal light remains illuminated, the function has been successfully
completed.
DANGER
WARNING
CAUTION
NOTICE
If you have levelled the chassis of the lift ON
A GRADIENT, turn the boom around carefully
to ensure that the turning device does not
bang against the support outriggers or other
obstacles.
Before using the lift, always check that:
• the chassis is in the horizontal position, in accordance with the position indicator
• the wheels are off the ground
• the outriggers are firmly supported on the ground
DANGER
WARNING
CAUTION
NOTICE
The operation is prohibited, if the lift is not properly supported and in a horizontal
position.
Observe the effect of ice, possible rain and inclination of the surface on the support
force (the support outriggers must not slip on the surface).