TPWX2GD/TPWX2GDI/TPW20IEX2GD 5
Use just the provided for battery; Contact Dini Argeo srl for further information.
Do not open, repair or modify a defective battery; this operation causes the loss of its intrinsic safety. Dispose of the
defective batteries.
The TPWX2GD atex pallet truck is an atex assembly composed of the TPW atex mechanical part, the DFWATEX2GD
atex weighing indicator and the atex load cell.
The TPWX2GDI/TPW20IEX2GD atex pallet truck is an atex assembly composed of the TPWX2GDI atex mechanical
part, the DFWATEX2GD atex weighing indicator and the atex load cell.
Read and follow also the atex manuals of the other parts: DFWATEX2GD atex weight indicator manual and the atex
load cell manual.
This scale has been designed to only weigh on pallets
Load only when forks are in the lowest position.
To get the best weighing results, lift up the forks (after loaded) about 5-10 cm.
It is not allowed to use the brake for slowing down, but only, and exclusively, for parking the already stopped pallet truck.
Check daily the status of the bearings and the bushings of the cart wheels and if there are problems such as frictions,
strange noises, overheating, offset
ting
of the wheels, etc., do not use the cart and contact the reseller for its repair.
The cart is grounded with a chain, check daily the presence of the grounding chain of the cart. Check daily that the chain
is clean, so that it can make the contact for the grounding of the Pallet truck. Do not remove the chain. The grounding of
the pallet truck is also possible by using Anti-Static wheels.
In case of approved scale, the weighing has to be done on a EUR-EPAL 800x1200mm pallet (ref. Norms UIC 435-2 and
UIC 435-4).
Contact Dini Argeo srl for further information.
For information on the operating mode of the weigh indicator DFWATEX, see the operating mode manual’s of the
indicator DFW downloadable from the website www.diniargeo.com.
This manual has been prepared with the maximum care, but any advice for improvements is most welcome.
