User’s Manual of DingTec® Laminators – BU-380 to 2040 Cold Laminator Series
5
Press the picture under the rollers, align it and flattening and secure the picture with
hands. If pressing roller is available, you can use it to pressing the picture on its head.
If the picture is thin and long, you can use double-sided adhesive tape to stick the
picture on the padding paper (as Figure 4 and 5). Another person should turn the
handle clockwise and press the picture into the rollers gradually. If everything goes
well, you can speed up to finish the laminating.
Figure 6
At the end of laminating, you should slow down and keep your hand on the end of the
film to avoid any unexpected dropping.
(ii) Reverse Laminating Method
Figure 7
Figure 8
1. Cut one piece of film at about the same size as the picture and make the film face up.
Then roll the picture with film and make sure they are well aligned. Put one side of
the roll between the two rollers of the cold laminator (make sure it is aligned
correctly). The head of the picture should be 30 cm longer than the rollers (Figure 9)
put down the rollers and turn the adjustable knob clockwise till idling.
2. Peel one side of the film off the padding paper about 10 cm, fold the padding paper
backwards (see Figure 9). After releasing the film, turn the handle counterclockwise,
Press the head of the picture and the film, to stick their together and make sure they
are still between the rollers. Roll up the film and the picture to let the folded padding
paper show up.
Figure 9
Figure 10