DINGLI S036-RS, Руководство оператора с информацией по обслуживанию

Страница: 27 / 64

OPERATOR’S MANUAL with Maintenance Information
Function Tests
22
exceeds 13.8 cm/s, immediately tag and
remove the machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with
the platform controller. Do not stand in the
platform.
40 Fully lower the platform.
41 Place a 3×20 cm or similar piece of wood
under both wheels on one side and drive
the machine up onto them.
42 Raise the platform approximately 1.3 m
from the ground.
⊙
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute.
The platform controls LED readout should
display LL.
43 Press the drive function select button.
44 Press and hold the function enable switch
on the control handle.
45 Move the control handle in the direction
indicated by the blue arrow, then move the
control handle in the direction indicated by
the yellow arrow.
⊙
Result: The drive function should not work
in either direction.
46 Lower the platform and drive the machine
off the block.
Test the Pothole Guards
Note: The pothole guards should automatically
deploy when the platform is raised. The
pothole guards activate another limit switch
which allows the machine to continue to
function. If the pothole guards do not deploy,
an alarm sounds and the machine will not
drive and lift.
47 Raise the platform.
⊙
Result: When the platform is raised
approximately 1.3 m from the ground, the
pothole guards should deploy.
48 Press on the pothole guards on one side,
and then the other.
⊙
Result: The pothole guards should not
move.
49 Lower the platform.
⊙
Result: The pothole guards should return to
the stowed position.
50 Place a 3×20 cm or similar piece of wood
under a pothole guard. Raise the platform.
⊙
Result: When the platform is raised
approximately 1.3m from the ground, the
pothole alarm will sound at 180 beeps per
minute, and the platform controls LED
screen readout should display 18.
51 Press the drive function select button.
52 Press and hold the function enable switch
on the control handle.
53 Move the control handle in the direction
indicated by the blue arrow, and then
move the control handle in the direction
indicated by the yellow arrow.
⊙
Result: The drive function should not work
in either direction.
54 Press and hold the function enable switch
on the control handle.
55 Depress the thumb rocker switch on top of
the control handle in the direction identified
by the blue and yellow arrow on the control
panel.
⊙
Result: The steer function should not work
in either direction.
56 Lower the platform and remove the 3×20
cm wood block.