After you press the button [OK], "
RUNNING
"
will be displayed for about 3 sec. After the initial
values are set, "
DONE
" will be appear on the
display.
"FACTORY DEFAULT" (Default factory setting)
To reset the initial values of the level meter set by the manufacturer, press the button
[OK]
(see
the Factory default table, p. 25)
"RESET" (Level meter restart)
Complete restart of the level meter. The same effect has also a short-time interruption of the supply
voltage. To enable the resetting, press the button
[OK]
.
During the restart process, "
RUNNING
" will be
displayed. Then the level meter will be automati-
cally turned off and on.
"HART" (HART address setting)
HART mode (point to point, multidrop) and multidrop mode address setting. Up to 15 units can be
connected to one two-wired cable in the multidrop mode.
In case of the address "00", the point to point
mode is enabled. The range from "01" to "15" is
reserved for addresses in the multidrop mode.
www.jetec.com.tw
久德電子
TEL:
+886-4-23729418
FAX:
+886-4-23724011
(40349)
台中市西區福人街11號
