21
©
Dinel, s.r.o. CLM–36
16 . General, conditions and warranty
Dinel, s.r.o. guarantees for the period of three (3) years that the product has the characteristics as
mentioned in the technical specification.
Dinel, s.r.o. is liable for defects ascertained within the warranty period and were claimed in writing.
This guarantee does not cover the damages resulting from misuse, improper installation or incorrect
maintenance.
This guarantee ceases when the user or the other person makes any changes on the product or the
product is mechanically or chemically damaged, or the serial number is not readable.
The warranty certificate must be presented to exercise a claim.
In the case of a rightful complaint, we will replace the product or its defective part. In both cases, the
warranty period is extended by the period of repair..
PROCEDURE FOR SHORTENING THE MEASURING ELEC-
TRODE ON VARIANT 30
1. At the cable electrode, it is necessary to loosen three fas-
tening screws on the ballast and to pull out the end of the
cable, see fig. 13.
2. Make sure that the cable length is correct after shorten-
ing – the cable is suspended in the ballast up to a distance
of approximately 60 mm. Ideally, shorten the cable using
diagonal cutting pliers. Be careful to prevent the end of the
cable from fraying.
3. Insert the end of the cable back into the ballast and secure
it in place by tightening all three screws.
60
Fig. 13: Drawing of the cable
electrode ballast
