Issued by: PM approved by DG Rev.07 date 12/06/16 pag. 5/6
Warning
Multiple trim maps will be created if multiple My Tuning Bike will be connected to the RapidBike
module or if a map for each gear ratio will be set (a trim map for each gear ratio will be created).
My Tuning Bike is equipped with two leds (red and blue) that allows to verify the installation of the device:
-
Red led off: device not powered
-
Red led on: device powered
-
Red led flashing: O2 sensor hot
-
Blue led off: CAN line communication off / CAN line communication error
-
Blue led flashing: CAN line communication on
Multiple My Tuning Bike connection
System requirements for n°2 My Tuning Bike:
-
2 cylinders engine where an O2 sensor for each exhaust port can be installed.
-
Rapid Bile Evo or Racing set with one map for each cylinder.
System requirements for n°3 or n°4 My Tuning Bike:
-
3 or 4 cylinders engine where an O2 sensor for each exhaust port can be installed.
-
RapidBike Evo o Racing set with one map for each injector. If the bike has 8 injectors the trim
map will adjust couples of injectors: 1-5, 2-6, 3-7 and 4-8.
WARNING: when multiple My Tuning Bike are connected, if the map configuration is wrong or there
is a problem on the connection of the devices, only the AFR value of the device ID01 will be used to
trim the injection.
1. Connect the wiring F27-TERM1 between the Rapid Bike wiring 3 pin connector marked as CAN and the
male 3 pin connector of the first My Tuning Bike (ID01).
Others My Tuning Bike must be connected in series to the first My Tuning Bike:
