15
Operation
D. Top Light Dimmer Control
The top Top Light Dimmer Control
controls the brightness of the top
accent light that is used to illumi-
nate the pebbles.
Resetting The Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the fire-
place off and it will not come back
on without being reset. It can be
reset by switching the 3-Position
Switch to OFF and waiting five
minutes before switching the unit
back on.
CAUTION:
If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).
Remote Control
The fireplace is supplied with an
integrated on/off remote control
!
NOTE:
Ensure that the fire-
place 3-Position Switch is set
to the remote control setting.
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace off.
!
NOTE:
Before attempting any
operation with the remote control,
pull the plastic insulator strip out
from between the remote casing
and battery cover.
Remote Control Initialization/
Reprogramming
15. Disconnect power to fire-
place.
16. Wait a minimum of 5 seconds
and then re-acquire power to
fireplace.
17. Within 10 seconds of re-
acquiring power, press the On
button located on the remote
control.
This will synchronize the remote
control and receiver.
Battery Replacement
(Figure 11)
To replace the battery:
1. Slide battery cover open on
the remote control.
Figure 11
Off
Button
On
Button
Battery
cover
Plastic
strip
