5
Mounting and Operating Instructions
TRFW 101, 151, 201 Electric Towel Warmer/Rapid Heater
453321.66.88gb 06/05/C
1. Important Notices
Read
all information contained in this manual carefully.
Keep these instructions in a safe place and hand them
over, if applicable, to the next owner.
−
The appliance is not intended for
use other than indoors, for the
heating of room air and for drying
towels, garments and similar textile
goods.
−
The appliance may only be installed by an authorised
qualified electrician.
−
All repairs and interventions in the appliance may
only be performed by qualified persons or the cus-
tomer service.
−
The hardwired electrical installation must be provided
with an all-pole disconnecting device with a contact
gap of at least 3 mm (e.g. automatic circuit-breaker).
−
For the installation of heaters in rooms with a bathtub
or a shower, it is imperative that the national electrical
codes and regulations be adhered to.
−
In the event of any defect (e.g. appliance or power
cord is damaged, unit is not working), the appliance
must be disconnected from the power supply. Deacti-
vate the circuit-breaker.
−
In the event of extended periods of non-use, the
appliance must be disconnected
from the mains power supply
.
−
Do not cover the heating appliance
as there is a risk of fire!
−
Do not allow appliance to be oper-
ated by children or other persons
not capable of safely using the device. Children must
be prevented from playing with or near the
appliance.
−
Caution! The outside of the appliance gets hot when
in use.
−
Do not insert any objects into the openings of the
appliance.
−
If the supply cord of this appliance is damaged it must
be replaced by a special supply cord which is avail-
able from the manufacturer or its service agent.
−
Do not use the appliance in areas where flammable
gases or liquids are stored or used.
−
Caution! After the appliance has been switched on
automatically, there is a potential fire hazard as the
appliance may have been covered or obstructed prior
to switching on.
−
Make sure that minimum clearances, in particular
from easily inflammable materials or heat-sensitive
plastic materials, are maintained (see Section "2.
Minimum Clearances")
−
The supply cord must not be placed
over the hot appliance.
−
The appliance must not be disposed in
the normal household rubbish.
2. Minimum Clearances, Mounting
The heating appliance may only be mounted and oper-
ated in vertical position on a vertical wall.
The appliance must be installed in such a way that
switches and other controls cannot be touched by the
person using the bath or the shower.
Do not mount the appliance directly under an electrical
wall outlet.
The mains socket must be accessible after the appliance
has been mounted.
It is absolutely necessary that the minimum clearances
indicated in the mounting diagram be maintained.
Beyond that, a clearance space of at least 500 mm is to
be allowed in front of the appliance.
Mounting procedure:
The heater must be fixed to the wall using 4 screws (see
diagram).
6. Loosen left and right quick-release screws and re-
move wall bracket.
7. Use the bracket holes to mark the holes for drilling.
8. Drill the holes, insert the wall plugs and secure
bracket to the wall using 2 screws each at the top and
bottom.
9. Engage heater in wall bracket.
10. Turn quick-release screws until the safety hook en-
gages the appliance back panel.
Dimensions in mm
280
200
431
167
16
A
330
46
TRFW 101
TRFW 151
TRFW 201
Dim. A 875 mm
1289 mm
1289 mm
200
150
100
100
Cable entry
