Dimplex Quantum series, Инструкция по установке и эксплуатации

Страница: 10 / 40

- 10 -
The controls are located on the top of the heater consisting of a display screen and three buttons and a Dial.
The heater is fi tted with an adjustable thermostat enabling the room temperature to be controlled. The minimum room
temperature is 7°C. The maximum temperature is set to 30°C by default. A temperature of 21°C is a common comfortable
room temperature.
NOTE:
Your heater may produce some noise during operation. This noise
is caused by the low noise fan and expansion and contraction of
the metalwork as it changes temperature, and is normal for this
type of product. Whilst the noise produced is usually very quiet,
certain environmental factors can make it more noticeable, such
as hard fl ooring or minimal furnishings.
Operation
H e a t i n g O N
1
5
2
6
3
MENU
BACK
ADVANCE
WARNING: FAILURE TO FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT IN INJURY AND/OR DAMAGE
NOTE:
Should the heater fail to
operate, this may be due to
the room temperature being
higher than the thermostat
setting.
O u t A l l D ay
1
Display Screen
2
‘Menu’ Button
3 ‘Back’ Button
4 ‘Selector Dial’
5
‘Enter’ Button
6
‘Advance’ Button
7
Heating Status
4
The heater controls can be easily adjusted by using the Dial and buttons on the User Interface.
1. The Home Screen shows the options available at each stage of adjustment. Here the current
target room temperature is displayed along with the mode of operation. Any use of the
Advance function will be displayed here, and pressing the
Dial
will show the functions
which are enabled.
The currently active mode of operation is displayed at the top of the screen e.g. ‘Out All
Day’ timer.
When the heater is in a timer profi le and trying to achieve or maintain a room temperature, ‘Heating On’ will be
displayed, otherwise, ‘Heating Off ’ will be displayed. The words ‘Heating On / Off ’ will not be displayed in a manual
mode of operation
When the controller buttons have not been pressed for a long period of time, the display will ‘sleep’ and the text
will disappear. The heater is still on and active in whatever Mode it was set to.
2. Menu
- Displays the Main Menu;
- Boost – Activate Boost Mode
- Modes - Set the mode of operation.
- Settings – Time/Date, Temperature units etc.
3. Back
returns to the previous screen.
4. Rotate the Dial to navigate through the menus and adjust the required room temperature on the main screen.
The screen colour changes based on the temperature selected, showing deep blue through to bright red.
5. Press the Dial to enter sub menus and to confi rm actions.
6. The Advance button is only used when a Timer Mode is active, it allows the timer schedule to be changed
temporarily by forcing a ‘Heating On’ period to begin or end early.
User Timer
21
°
C
Heating ON
7