Convector Heater
PLX075NN/PLX100NN/PLX150NN/PLX200NN
1. Important Information
Please read carefully all the information provided in
these instructions. Keep the instructions in a safe place
and if necessary give them to any future owner.
-
The device may only be installed by an authorized
and qualified technician.
-
The unit may only be used for space heating in
enclosed rooms.
-
Any examination of the heater or repair work may
only be carried out by a qualified electrician.
-
Disconnect the heater from the power supply if it is
faulty or is not used for a long time. Disconnect or
shut off the power at the breaker.
-
Do not cover the heater in any way (risk of fire).
-
Warning: Outer surfaces become hot when heater
is switched on.
-
The heater must not be operated by children or
other persons not capable of using the appliance in
a safe manner. Children must be prevented from
playing with the appliance.
-
Do not insert any objects into the openings.
-
Do not use the heater in rooms containing
flammable materials (e.g. solvents, etc.).
-
Do not place the connecting lead on top of the
appliance.
WARNING:
If the heater is switched on automatically, there is a
danger of fire if it has been in any way covered or
blocked.
2. Positioning, Installation, Minimum Clearances
When installed, the heater must be aligned horizontally
on a vertical wall, as shown in the illustration.
The minimum clearances shown must be complied
with.
In addition, a minimum distance of at least 20” must be
maintained in front of the heater.
The heater must not be located directly beneath a wall
socket outlet.
Do not install the heater where the controls can be
reached by a person bathing or showering.
CAUTION:
Do not place near flammable objects.
Ensure that air can enter and leave the heater freely, at
the inlets below and the outlets above.
The recess box must be accessible for inspection after
the appliance has been mounted.
Wall Mounting
IMPORTANT
The original wall brackets supplied attached to the rear
of the unit must be used.
- Drill mounting holes for the wall brackets.
- Screw the brackets securely to the wall.
- Hang the heater from the wall brackets using the slits
in its rear wall.
- Secure the heater at the top on the wall brackets.
3. Electrical Connection
All wiring must comply with National Electrical codes
and local codes and utility requirements. This
installation should be entrusted to duly qualified
personnel where required by law.
Connect the supply wire into a properly rated recess
box. Consult your local electrical code for applicable
wire gauge. Connect L1 from the power supply to the
blue wire from the unit, connect the L2 wire from the
power supply to the brown wire from the unit, and
connect the ground to the yellow/green wire from the
unit.
5 15/16”
5 15/16”
5 15/16”
16 15/16”
1-888-346-7539
7207930100r01
