Quick Start Guide
How does the heater control work?
The PLXENC panel heater has the full feature-set of the PLXE panel heater, without the on-board controls. Programming of the heater can be made via the ConfigR app,
and controlled either via the DWC (Dimplex Wall Controller) or smartphone / tablet via the Dimplex Control app* ** (NOTE: The DWC unit is sold separately).
Operation
The user interface is located at the top of the heater consisting of three capacitative buttons for connectivity and four LEDs to communicate the operation.
All further operation will be made via the DWC (Dimplex Wall Controller) or by mobile application **
First Time Start Up
1.
Plug in the product to power supply and turn on
2.
Status LED will turn on to indicate product is on. The product will be in frost protect mode by default.
3.
Connect the product via Bluetooth or through the Dimplex Control app **
3.1. To connect the product via Configr, install the Configr app and follow the instructions. To enable Bluetooth on the product, see ‘Bluetooth Pairing’.
3.2. To connect via Dimplex Control app, install the RF Module. To do this, unhinge the heater from the wall using the clips shown in Fig.2 and locate the battery
module. Slide the catch and pull module from the controls. Replace the battery tray with the RFM. Power on the product and follow instructions in the app.
3.3. If using the DWC (Dimplex Wall Controller), use the Bluetooth app to connect the products.
Bluetooth Pairing
Press and hold the Bluetooth capacitive button for 3 seconds to begin broadcasting a signal to be paired via Bluetooth. The Bluetooth LED will then flash to indicate
the heater is in pairing mode. Once paired the Bluetooth LED will remain lit.
NOTE: If no connection is made within 2 minutes, the product will stop broadcasting a Bluetooth signal.
This product is Dimplex Control capable * **.
Control and monitor your heating and hot water with Dimplex Control.
Group heaters into zones to easily control and track their energy usage, anytime, anywhere.
Search for Dimplex Control on your device’s app store.
*Requires additional hardware.
Sold seperately.
Visit Dimplex.co.uk for more information.
**A Dimplex Hub and RFM are required for this product to connect to Dimplex Control.
INSTALLER
INFORMATION
As an installer,
the ConfigR app
will allow you to seamlessly install, commission and maintain heating systems.
• Installation and configuration settings
• Maintenance
• Viewing error codes and diagnostic reports
• Downloading and applying software updates
This QR Code will link you directly to the ConfigR app on the Android and Apple app stores for detailed information on heater setup, programming and fault code
an
a
lysis assistance .
