Energy Related Product Directive
This product complies with Lot20 of the Energy Efficiency Directive (2015/1188)
General Information
The heater is designed for wall mounting using the wall bracket supplied. It should only be operated when in the upright position as shown (see Fig. 1 on page 1).
All models are splash proof to IP24. Before connecting the heater check that the supply voltage is the same as that stated on the heater.
Wall Mounting
IMPORTANT The wall bracket supplied with the heater must be used and the heater must be installed in the correct orientation.
The fixings should be used to secure the bracket to the particular wall on which the heater will be installed.
The heater should be positioned observing the minimum clearances stated around the heater (see Fig. 1 on page 1).
Model Identifier(s):
PLX050ENC
PLX075ENC
PLX100ENC
PLX125NCE
PLX150NCE
PLX200ENC
Heat Output
Nominal heat output
Pnom
0.50kW
0.75kW
1.00kW
1.25kW
1.50kW
2.00kW
Minimum heat output
(indicative)
Pmin
N.A
N.A
N.A
N.A
N.A
N.A
Maximum heat output
Pmax,c
0.50kW
0.75kW
1.00kW
1.25kW
1.50kW
2.00kW
Auxiliary electricity consumption
At nominal heat output
elmax
0.00
0.00
0.00
0.00
0.00
0.00
At minimum heat output
elmin
0.00
0.00
0.00
0.00
0.00
0.00
In standby mode
elSB
<0.0005
<0.0005
<0.0005
<0.0005
<0.0005
<0.0005
Type of heat output / room temperature control
Type of heat output / room temperature control
Electronic heat charge control with room and / or
outdoor temperature feedback
Yes
Other control options
Room temperature control, with open window
detection
Yes
With adaptive start control
Yes
To mount the heater to the wall:
1. Remove wall mounting bracket from the back of the heater by depressing
the spring latch at the side of each bracket - see Fig. 2.
2. Fix the wall bracket securely to the wall through the four screw holes.
3. Present the heater to the wall bracket and engage bottom slots in the
back with bracket hooks.
‘D’
‘E’
255
310
Minimum mounting clearance
WARNING:
This product is heavy and care should be taken in installation .
Fig. 2
IMPORTANT: Please register your product without delay. Simply scan this QR code using your smartphone, or go to
https://www.dimplex.co.uk/register.
If you do not have access to the internet, please call us on 0344 879 3588
Product Registration
