2
DF3215
REMOTE CONTROL
The remote control has a range of approximately 50 ft. (15.25m), it does not have to be
pointed at the fireplace and can pass through most obstacles (including walls). It is
supplied with 243 independent frequencies to prevent interference with other units.
BATTERY INSTALLATION
1. Depress tab on the battery cover on the back of the remote transmitter and
remove battery cover.
2. Install 3 AAA batteries into the remote control (included).
3. Replace the battery cover.
NOTE
The remote transmitter has a battery backup time of 24 hours. The batteries can be
removed for up to 24 hours before the transmitter will require re-initialization.
NOTE
When the
Low Battery
icon is present on the remote control it is recommended to
replace the batteries promptly, to maintain full functionality of the remote/fireplace
(FIGURE 5).
INITIALIZING THE REMOTE CONTROL
1. Plug cord into 120 volt wall outlet.
2. Turn ON the electrical power at the circuit breaker.
3. Ensure the Main On/Off switch located inside the fireplace in the upper right hand
corner is in the ON position.
4. Set the 3 position manual control to Position 1 (left position).
5. Press and hold the initialization button on the unit.
6. While holding the initialization button, press the flame/heat ON/OFF button or
the Purifire™ ON/OFF button on the remote control transmitter.
7. Release the initialization button on the unit. The remote control is now ready for
operation.
Batteries
Indicator
Light
Initialization
Button
3 Position
Manual
Control
FIGURE 2
FIGURE 3
Main
On/Off
Switch
SERIAL No.
XXX
XX
