Dimplex DXDB20E, Инструкция по установке и эксплуатации

Страница: 8 / 10

Drainage
While the water tank is full, the compressor will stop for self-protection and the water
full indicator will turn red.
To remove the water tank, pull it out squarely and horizontally from the unit.
After empting the water tank, place the water tank carefully and gently back into its
location. The water tank must be properly positioned, in order for the 'water full' sign to
go out and for your dehumidifier to operate.
Please note, if the water tank has not been positioned correctly the water full indicator
will turn red and remain on.
Continuous drainage
When the dehumidifier is operated at very high humidity levels, the water tank will
require more frequent emptying. In this situation, it may be more convenient to set the
unit up for continuous drainage by following the
instructions below.
1. Remove the water tank.
2. Connect a flexible plastic water pipe of inner
diameter: 11 mm. directly to the drain tube of the
appliance (* Please note, the water tube is not
supplied with the unit).
3. Ensure the drain pipe is securely fitted and
replace the water tank carefully routing the
flexible drain pipe out over the top of the tank
as shown.
4. Ensure the free end of the pipe runs to a
permanent drain and that the flexible pipe
outlet is below the level of the appliance
outlet connection.
5. Note! In very cold weather conditions,
precautions should be taken to prevent the
water tube from freeing.
7
Water tube of
inner diameter
11 mm