Dimplex DHW 250P, Инструкция по установке и эксплуатации

Страница: 38 / 60

EN-18 FD 0207 www.dimplex.de
English Faults
12.3. Change
Changes on the device are prohibited. Any compo-
nent replacement must be carried out by a specialist
with original spare parts from the manufacturer.
12.4. Decommissioning
Temporary decommissioning of the device
NOTE
i
For periods of prolonged absence where the power
supply in the residential unit and to the device is
switched off, the device must be emptied with the
help of a qualified specialist and protected from frost.
Permanent decommissioning of the device
NOTE
i
The device must be decommissioned by a specialist
technician.
12.5. Disposal
ATTENTION!
The device must be de-energized before de-
commissioning and disassembly.
ATTENTION!
The storage heater may only be disassem-
bled by a qualified specialist.
These devices are free from asbestos and can be
completely dismantled without concerns.
The device must not be disposed of as
household waste, but must be taken to a
local disposal point.
Please store removed domestic hot water
heat pumps in a dry place throughout the
entire disposal chain, as trace elements may other-
wise enter the groundwater.
Disposal of refrigerant
NOTE
i
The device contains the refrigerant R290 (propane).
NOTE
i
The refrigerant must always be disposed of by a spe-
cialist.
NOTE
i
Observe the general safety regulations.
12.6. Drainage

Disconnect the device from the power supply.

Close the cock on the cold water inlet of the safety
group. Ensure that the air supply (rear ventilation)
is present at the highest point.

Open the domestic hot water cocks.

Bring the safety group into the draining position.
12.7. NTC sensor characteristic curve
The 4 probes have the same curve with regard to the
ohmic values.
0
5
10
15
20
25
30
35
40
45
50
55
60
-10 -5 0 5 10 15 20 25 30 35 40
Temperature (°C)
(kOhms)
Resistor