– 8 –
9. When both the time and temperature are set, the LED display will switch between
showing the set temperature and timer setting every 30 seconds. When a timer is not
set, it will only show the set temperature.
10. When the heater is turned on or in standby mode, press
button to turn on/off the
flame effect function, the LED will light up/off accordingly.
11. Memory function in standby mode:
When the heater is turned on (except for the first time), under standby mode, the unit
will revert to the last used setting (except for the timer).
12. After working for 1 minute, the brightness of the LED display will reduce to 1/3 of the
normal brightness. It will resume to the normal brightness when any operation of the
device is activated.
13. If the unit falls over the tip-over switch inside the heater will disconnect the heater
automatically.
14. Remarks:
a) when the over-heat sensor is activated (temperature is above 60ºC),the LED
display will display “EE”, and the heater will turn off.
b) When the environment temperature is lower than -10ºC, the LED will display “LO”
c) When the environment temperature is higher than 40ºC, the LED will display “HI”
MAINTENANCE AND CLEANING
1. Before any cleaning or maintenance, make sure the heater is completely turned off,
and the power cord is not connected to the wall socket.
2. Use a soft cloth to wipe the dust off the heater’s surface; If the surface is very dirty, use
a moist soft cloth to wipe it with water less than 50°C mixed with a neutral detergent.
3. Do not use gasoline, thinner or any other chemicals that can damage the surface.
4. Before storing the heater, let it cool down and store it in a dry and ventilated area.
5. Warning: any other servicing should be performed by an authorized service
representative.
14064_DHCER20FE Manual_V2.indd 8
7/12/17 4:25 PM
