– 6 –
PRODUCT OPERATION INTRODUCTION
INSTALLATION METHOD
1. Take the device out of the bubble wrap, including the following three parts; heater,
base and remote control.
2. Put the heater on a flat surface upside-down (with the base facing up). Connect the
base with the heater.
3. Turn the unit right way up.
4. Press Power button which is in the back of the device, to turn on.
REMOTE CONTROL OPERATION PANEL
1. Pull out the battery cover on the back of the remote control.
2. Pay attention to the battery polarity, and insert the battery (CR2032) into the tray of
the panel.
3. Push the battery cover back into the remote control.
Page 6
l
bein
Product Operation introduction
Installation method
1. Take the device out of the bubble wrap, including the following three parts;
heater, base and remote control.
2. Put the heater on a flat surface upside-down (with the base facing up). Connect the
base with the heater.
3. Turn the base right way up.
4. Press Power switch which is in the back of the device to turn on.
Remote control operation panel
1. Pull out the battery cover on the back of the remote control.
2. Pay attention to the battery polarity, and insert the battery (CR2032) into the tray
of the panel.
3. Push the battery cover back into the remote control.
The function of buttons
The fan will operate whenever the heater is heating. If the heater stops working,
then the fan will stop working after 10s.
①
After connecting to the power supply and switching on the power, you will hear a
beeping sound, the heater then enters Standby Mode. The power indicator
ights up.
②
Under standby mode,
key to turn on/off the heater. When turning off the
heater, the display panel and fan will then countdown (from 10 to 0 second) before
switching off.
③
The default setting after
g switched on is:
a) Heater
：
low power,
lights up.
b) Oscillation
：
off,
lights off.
c) Timer
：
0 hrs,
lights off.
d) Fan
：
turned on.
e) Temperature setting
:
the default temperature setting is 25
℃
.
f) Fireplace display
：
turned on, lights up.
g) ECO: turned off,
lights off.
THE FUNCTION OF BUTTONS
The fan will operate whenever the heater is heating. If the heater stops working, then
the fan will stop working after 10s.
1. After connecting to the power supply and switching on the power, you will hear a
beeping sound, the heater then enters Standby Mode. The power indicator
lights up.
2. Under standby mode,
key to turn on/off the heater. When turning off the
heater, the display panel and fan will then countdown (from 10 to 0 second) before
switching off.
3. The default setting after being switched on is:
a) Heater: low power,
lights up.
b) Oscillation: off,
lights off.
c) Timer: 0 hrs, lights off.
14064_DHCER20FE Manual_V2.indd 6
7/12/17 4:25 PM
