Parts
Assembly
First assemble the base to the main pillar - refer to Fig. 1 & instructions below:
Rear Guard
Motor housing
Stand base
Main pillar
Height adjustment
knob
Upper pillar
Bolt
Power cord
Speed control
Fixing screws
Motor shaft
Fan blade screw
Fan blade
Front guard
Weight
Speed control
Clamping washer
L-shaped screw
1. First unscrew the L-shaped screw (18) and remove it and the clamping washer
(17) from the bottom of the main pillar (6).
2. Turn over the stand base (15). Place the weight (16) in its place on the underside
of the base and place the clamping washer (17) in the centre of the weighted
base (16).
3. Thread the L-shaped screw (18) through the assembly and into the thread of
the main pillar (6). Tighten firmly, but do not overtighten.
4. Loosen the height adjustment knob and pull the upper pillar out of the main
pillar and secure the knob to the desired height.
Secondly, attach the motor housing to the base & upper/main pillar - refer to Fig 2
& the instructions below:
1. First remove the pivot knob (7) and the bolt (20) from the top of the upper
pillar (6), then remove the neck retaining screw (8) and small adjustment knob
(19) from the motor housing bracket.
2. Place the motor housing on the top of the upper pillar and thread the large
pivot bolt (20) through the bracket. Screw in the small retaining screw (8) and
tighten, but do not overtighten.
3. Fit the large pivot knob (7) onto the end of the bolt (20) and the small
adjustment knob (19) at the other side above the bolt. Tighten the knobs while
holding the fan motor upright.
Retaining clip
Pivot knob
Adjustment knob
Neck Retaining
screw
Screw
Nut
7
6
