Functions
HUMIDIFY
To activate the
HUMIDIFY
function, press the
HUMIDIFY
button once to turn on.
Ensure there is enough water in the water tank. The LED indicator light will illuminate
once activated. Press this button again to turn off the
HUMIDIFY
function, and to
use as a fan only.
The unit is also equipped with the below functions.
LOW WATER PROTECTION
When there is insufficient water in the water tank, the pump will stop working for
1 minute, and then the
LOW WATER
indicator will start to flash. It won't stop the
other functions from working, just the
HUMIDIFY
function. Fill the water tank if this
happens.
DIM DISPLAY
When the unit is working, after 40 seconds of any buttons being pressed, the
indicator lights will dim. Press any button (except for the
ON/OFF
button) and the
indicator lights will reactivate.
MEMORY FUNCTION
This unit has a memory function. When the fan is turned
OFF
, it memorises the
settings previously used. When the unit is turned
ON
again, it will start in the same
settings as previously used (unless the power supply was fully disconnected). If the
unit was in
SLEEP
mode previously, it will start in natural wind mode.
AUTO OFF
If there isn't any change in settings after 15 hours of constant use, the unit will turn
OFF
automatically. This is an additional safety feature in case the unit is left
ON
accidentally.
FILTER REMOVAL PROTECTION
If the filter has been removed during operation (not recommended!), the unit will
stop working until the filter is replaced. The unit will enter standby mode and will
need to be turned
ON
again if this happens.
REMOTE CONTROL
This unit comes with a remote control, and all settings can be control via the remote.
9
