Dimplex Coldwatcher MPH 500 Скачать руководство пользователя страница 4

 
THE ELECTRICITY SUPPLY TO A 
GREENHOUSE SHOULD BE INSTALLED BY A 
COMPETENT ELECTRICIAN IN ACCORDANCE 
WITH THE lEE WIRING REGULATIONS. IT IS 
RECOMMENDED THAT RESIDUAL CURRENT 
CIRCUIT BREAKER (RCCB) PROTECTION IS 
USED. 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Using the heater in an 
Airing Cupboard 

The heater is suitable for use in an airing cupboard 
where there is no other heat source, or where the  
hot water cylinder is so well insulated that insufficient 
heat is available for airing clothes. 
The airing cupboard should be ventilated by means of  
vents for example in the upper and lower parts of the  
door. This will allow circulation and removal of moisture  
laden air. 
The heater should be positioned in the lower part of the  
airing cupboard. 

IT IS IMPORTANT THAT PRECAUTIONS ARE  
TAKEN TO PREVENT CLOTHES FROM FALLING  
ON TO THE HEATER CAUSING IT TO OVERHEAT.  

This could take the form of a wire mesh positioned  
across the lower part of the airing cupboard not  
less than 300mm above the heater. (Also refer to “Heater  
Dimensions and Minimum Operating Distances”). 

 

 
 
 
 
 
 
 
 
 
 

 

The product complies with the European Safety Standards EN60335-2-30 and the European EN5501 4, N60555-2 and EN60555-3 for 
Electromagnetic Compatibility. This standards cover the requirements of EEC Directives 73/23 and 89/336. 

 
Glen Dimplex UK Limited  

UK customer help line (8.00AM – 6.00PM Mon-Fri; 8.30AM-1.00PM Sat)                  

Millbrook House 
Grange Drive  

Customer Services:     Tel.    0870 7270101 

Hedge End            

 

           Fax.  0870 7270102 

Southampton 
Hampshire   

Republic of Ireland        01. 8424833 

SO30 2DF

 

The heat output of the MPH500 is similar to that of a small 
single burner greenhouse paraffin stove and the MPH1000 
has an output similar to that of a small double burner paraffin 
stove. However, both have the advantage that they may be 
switched on overnight as a precaution against frost with the  
knowledge that they will not consume current on  
the frost setting unless the temperature in the vicinity of the 
heater falls below approximately 5°C. If only one heater is 
being used in a full size greenhouse, it will be necessary to 
partition off that which requires frost protection, using for 
example heavy duty polythene sheeting, which can also be  
used to line the glazing of the greenhouse to reduce 
heat losses and therefore power consumption. 
As a guide to the effectiveness of a single MPH500 
Coldwatcher in a greenhouse, it will raise the temperature of 
the shaded section of the greenhouse by approximately 8 – 9 
°C. The MPH1000, however, would raise the average 
temperature of the whole greenhouse shown by 
Approximately the same level. For example, if the outside 
temperature is -2ºC the MPH500 should be able to keep the 
temperature at 6-7ºC within the partitioned off section. If 
higher temperatures are required then the volume partitioned 
off should be made smaller.  In this respect the only accurate 
method is to set the thermostat to the position which keeps 
the temperature at the desired level by using a 
maximum/minimum thermometer, positioned in the most 
critical part of the area to be heated.  Although the heater is 
designed to be splash-proof it is recommended that it be 
removed during periods when spraying is being carried out in 
the greenhouse.   

Clothing, bed linen or similar items 

must 

not be 

stored in this space if there is 

any 

possibility of their 

falling on to or against the heater or coming within 
150 mm of the front or sides of the heater. A clear 
space of 300 mm 

must 

similarly be left above the 

heater. 
If this space is to be used for storing such items, a 
further mesh should be fixed not less than 150mm 
from the front of the heater.

After Sales Service 

 
Your product is guaranteed for one year from the date of purchase.  We undertake to exchange or repair free of charge within this period, any 
part found to be defective due to a manufacturing fault.  This guarantee in no way prejudices your rights under common law. 
Should you require after sales service, please contact the supplier through whom you purchased the appliance or your nearest Dimplex 
Service Agent. 
Please do not initially return a faulty appliance or part of an appliance to us as this may result in transit damage and/or delay in providing 
service.  Let us know your difficulty quoting the details shown on the rating label, and we will then take the appropriate action. 

Отзывы: