23
Before commencing cleaning, isolate the heater from the electrical supply and allow it to cool.
The outside can be cleaned by wiping it over with a soft dry cloth. Do not use abrasive cleaning
powders or furniture polish, as this can damage the surface fi nish. To release the heater from the
wall bracket for cleaning or redecoration, depress the
latch on both brackets (See
Fig. 2, page 6
) and hinge forward.
Cleaning
RF Module Installation
1. Unhinge the heater from the wall using the clips shown in Fig. 2 (page 6) and locate the
battery module, indicated in Fig. 5
2. Slide the catch and pull module from the controls (See Fig 5; 1-3).
3. Replace the tray with the radio freqency module
4. Power the product on and make sure that the RF comms are enabled. Comms settings will
be located in the settings menu (see page 19)
During the initial operation, some odour may be noticed due to the newness of materials used in
manufacture. This is normal and will disappear after a short period of use. It is however advisable
to keep the room well ventilated
Important
WARNING - ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER.
This product is Dimplex Control capable * **.
Control and monitor your heating and hot water with Dimplex Control. Group heaters into zones to easily control and track their energy usage. Any
time. Anywhere
Search for
Dimplex Control
on your device’s app store.
*
Requires additional hardware. Sold seperately. Visit Dimplex.co.uk for more information.
**A Dimplex Hub and RFM are required for this product to connect to Dimplex Control.
Search for
Dimple
