In keeping with our policy of continuous product improvement, we reserve the right to make changes without notice.
© 2011 Dimplex North america Limited
1367 Industrial Road Cambridge ON Canada N1R 7G8
1-888-346-7539 www.dimplex.com
3
cAuTiOn:
Before removing the front cover for cleaning,
make certain the power has been turned off at the circuit
breaker panel.
cAuTiOn:
Allow adequate time for the element and body
casing to cool before attempting to work on the heater.
The AF6 and AS8 series contain no moving parts. Since the
appliance contains no moving parts, little maintenance is
required beyond vacuum cleaning. it is, however, essential
that the heater is not operated with an accumulation of dust
or dirt on the element, as this can cause a build up of heat
and eventual damage. For this reason the heater must be
inspected regularly, depending upon conditions and at least
at yearly intervals. Once cleaning is complete replace the
front cover and restore power.
WArninG:
The user can perform cleaning ONLY, all
other servicing should be performed by qualified service
personnel.
maintenance
Warranty
The Manufacturer warrants the heating elements and
components of the enclosed product against any defect in
material or workmanship for a period of one year from the
date of purchase. In full satisfaction of any claims under
this Warranty the Manufacturer will repair or replace without
charge, in its factory or in the field as it alone may decide,
any parts which in its opinion are defective.
The Manufacturer shall not be responsible for any
transportation or shipping costs in relation to such repair
or replacement except as specifically assumed by it.
Misuse of this product or repairs by persons other than
the Manufacturer’s authorized personnel without the
Manufacturer’s written approval, will void this Warranty.
This Warranty is in lieu of all other warranties or conditions
whether expressed or implied including but not limited to
those of merchantability or fitness for purpose and shall
constitute the sole remedy of the Purchaser and the sole
liability of the Manufacturer in respect of the sale of the
product, whether in the nature of breach or breach of
fundamental term, or of negligence or otherwise.
The Manufacturer shall not be liable for any special, indirect
or consequential damages or for any damages resulting from
removal or replacement of a heater subject to warranty claim
without the Manufacturer’s authorization.
This Warranty is transferable by the original consumer
purchaser of the product. Any claims under this Warranty
must be submitted in writing to the service manager, Dimplex
North America Ltd., 1367 Industrial Rd., Cambridge, Ontario
N1R 7g8, Canada.
This heater must be properly installed before it is used.
1.
prior to energization remove all construction dirt (plaster,
2.
sawdust, etc.) from interior and exterior of heater.
Dimplex baseboard heaters are designed and tested for safe
and trouble-free operation. All Dimplex baseboard heaters
are protected against overheating by a built-in thermal cutout.
Free airflow throughout the heater is extremely important for
the most efficient operation of the heater. Restricted airflow
may cause the thermal overload protector to cycle the heater
“ON and OFF”. A cycling heater will not supply sufficient heat
to the room.
Avoid direct contact of paper, fabric, or furniture with heater.
Operation
Terminal Box Volumes in Cubic inches
Heater style
Left Hand Box 4”
Wide
Right Hand Box 5”
Wide
AF6, AS8
33.25
41.50
Do a final and complete check of all wiring then replace
4.
the terminal box covers being careful not to pinch any
wires.
The front/top panel may now be installed.
5.
WArninG:
TO PReveNT THe RISK OF FIRe, DO NOT
OPeRATe THe HeATeR WITHOUT THe FRONT/TOP
paNELs iN pLaCE.
p
•
lace the front panel over the flange of the bottom panel.
Hook the top back edge of the front panel over the top
•
panel, and snap onto the plastic clips.
