400
265
Access Panel
Doorway
Fig. 7
275
Fig. 5
85
145
120
134
48
75
1
2 3
Fig. 1
Fig
Fig
Fig
Fig
Fig
Fig
. 1
500mm
105mm
271mm
579mm
Fig. 6
WARNING:
The Switch Panel should not be installed in a toilet or washroom.
The backing box (standard B.S. double gang as shown in
Fig. 5
) should be
fi xed to a suitable wall. Suitable wall conduit should be used where applicable
to carry the cable between the heater and the switch panel. A suitable recessed
wall box may be substituted, as an alternative.
Installation of Heater
The Installation of this product must only be carried out by a prescribed
competent person in accordance with Building Regulations and the current IEE
Wiring Regulations for electrical equipment.
This heater can either be installed into a suspended or plasterboard ceiling.
First it is necessary to ensure that there is suffi cient space above the ceiling
for the Installation of this product (see
Fig. 1
and
Fig. 7
).
This product is designed to be suspended by threaded rod or wires/chains.
Always ensure this unit is adequately supported when installed.
Installation in a Ceiling
A hole as indicated in
Fig. 1
and
Fig. 6
must be cut into the ceiling. Allow an additional
amount for clearance. It may be necessary to fi x an internal supporting frame
around the newly cut aperture in a plasterboard ceiling or suspended ceiling.
To mount the unit into the ceiling void, use lengths of threaded bar or hooks
(not supplied) screwed into the M8 threaded inserts located in the top side of
the heater (see
Fig. 1
for dimensions). Adjust the height of the heater so the
inner edge of the grill surround is fl ush with the ceiling.
Installation in a Bulk Head
(over doorway)
A hole (579x271mm) as indicated in
Fig. 7
, must be cut into the ceiling part
of the bulk head. Drop rods should be
used to mount the appliance in such a
position, as to have the base fl ush with
the ceiling. An access panel should
also be provided on the front of the
bulkhead. This provides access to the
top of the appliance and cable entry
point. Access for wiring the appliance
is via the grille.
Operation of Switch Panel
Switch on electrical supply (MAINS IN)
to the Switch Panel.
Switching the switch marked ‘
I
’ (see ‘1’ in
Fig. 5
) energises the fan and switches
on the electrical supply to the heater.
The heat selection switches allow heat settings to be chosen as shown
below:
Settings -
I
Fan Only
I +
Fan +
1
/
2
Heat
I +
Fan + Full Heat
The desired setting can be obtained through switch selection.
WARNING
This heater is not equipped with a device to control the
room temperature. Do not use this heater in small rooms when they
are occupied by persons not capable of leaving the room on their own,
unless constant supervision is provided.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or metal capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the
appliance.
Содержание AC3CN
Страница 7: ......
