8 www.dimplex.com
34.1 in.
(867 mm)
19.4 in.
(494 mm)
7.0 in.
(179 mm)
32.4 in.
(823 mm)
30.0 in.
(761 mm)
6.8 in.
(172 mm)
18.0 in.
(457 mm)
16.0 in.
(406 mm)
3.8 in.
(95 mm)
!
NOTE:
If the surface you are using as a work area on is
a finished surface that is prone to scratches (i.e. hardwood
flooring), it is recommended that a protective barrier be
used underneath, (i.e. cloth, cardboard, thick plastic).
5. Proceed to the instructions within this manual relating
to the repair being performed - see Table of Contents
for page number.
6. Once repair is complete, reassemble in the reverse
order as above.
Recessed Mount - Partial In-wall
(Figure 7)
Tools Required:
Phillips head screwdriver
CAUTION:
Follow “Preparation for Service” instructions
before proceeding.
1. Remove the decorative acrylic ember-bed pieces from
the media tray, which lies along the bottom of the inte-
rior Partially Reflective Glass. A medium sized con
-
tainer such as a bucket or a box will be needed to keep
the acrylic ember-bed pieces together.
2. Locate and remove the 4 mounting screws located
approximately 3 inches deep in the space between the
outer and inner casing on the left and right hand side.
There are 2 screws per side, upper and lower going
into a stud. (Figure 7)
CAUTION:
The fireplace should be supported while
removing the screws to prevent the unit from falling.
3.
Remove the fireplace out of the opening by slightly lift
-
ing and pulling forward.
4.
Carefully lay the unit down on a solid flat surface with
the front of the unit facing up.
!
NOTE:
If the surface you are using as a work area is a
finished surface that is prone to scratches (i.e. hardwood
flooring), it is recommended that a protective barrier be
used underneath, (i.e. cloth, cardboard, thick plastic).
5. Proceed to the instructions within this manual relating
to the repair being performed - see Table of Contents
for page number.
6. Once repair is complete, reassemble in the reverse
order as above.
Flush Mount – Complete In-wall
(Figure 8)
Tools Required: Phillips head screwdriver
CAUTION:
Follow “Preparation for Service” instructions
before proceeding.
1. Remove the decorative acrylic ember-bed pieces from
the media tray, which lies along the bottom of the interi-
or Partially Reflective Glass. A medium sized container
such as a bucket or a box will be needed to keep the
acrylic ember-bed pieces together.
2. Locate and remove the 4 mounting screws inside the
unit located on left and right side towards the front.
Figure 5
Figure 6
Wall Mounting
Bracket
Bottom Support
Bracket