Dillon AP Dynamometer, Руководство по установке

Страница: 5 / 12

Use only the hardware supplied with this instrument. If no
hardware was supplied, insure that the mating pin and
shackle bow is equivalent to the hardware used at
calibration. Otherwise substandard performance or failure
can result.
Dillon recommends only using qualified rigging hardware
and cannot be responsible for unapproved hardware.
This instrument is not designed for the following:
l
Applications that see rapid, dramatic
temperature swings or thermal shock. Wide
variation in readings can occur.
l
Intrinsically safe environments. This unit
has not been Factory Mutual or ATEX
tested.
1.4 Routine maintenance
1.5 Cleaning the Dynamometer
Cleaning DOs and DON’Ts
l
DO - Wipe down the outside of standard
products with a clean cloth, moistened with
water and a small amount of mild detergent
l
DO NOT - Attempt to clean the inside of the
machine
l
DO NOT - Use harsh abrasives, solvents,
scouring cleaners or alkaline cleaning
solutions
1.6 Training
Do not attempt to operate or complete any procedure on a
machine unless you have received the appropriate training
or read the instructions.
IMPORTANT: This equipment must be
routinely checked for proper operation
and calibration.
Application and usage will determine the
frequency of calibration required for safe
operation.