Release 1.0
Digium, Inc.
Page 30
Chapter 2: Card Installation
Software Installation
The card is only supported under Linux. Digium, Inc. recommends
Debian, Fedora, and Red Hat, however, all other distributions are
supported by Digium Technical Support. Digium hardware requires
drivers and libraries that are integrated with the Linux kernel. You can
obtain the source code from
ftp.digium.com
. Detailed instructions are
provided in this section.
To install software for your TE400 Series card, you will need:
Full Linux kernel 2.6 (or later) source code.
Development libraries and headers for libncurses (only necessary for
Asterisk).
Development libraries and headers for zlib and openssl.
If you are using the 1.2.x series of Asterisk and Zaptel, you will need
Asterisk 1.2.18 or newer, and Zaptel 1.2.18 or newer. If you are using
the 1.4.x series of Asterisk and Zaptel, you will need Asterisk 1.4.4 or
newer and Zaptel 1.4.3 or newer. If you are using Asterisk Business
Edition, you will need version B.2 or newer.
Caution.
This unit must be connected to the Telecommunications
Network in your country using an approved line cord, e.g.: for
Australia use only line cords complying with ACA Technical
Standard TS008.
Caution.
This unit must be connected only to the appropriate
Telecommunications Network port (as approved for use in your
specific country).
