22
Chapter 3 How to Login the Switch (16 port)
3.3 Switch to End Node (16 port)
Use standard Cat.5/5e Ethernet cable (UTP/STP) to connect the Switch to end nodes as
described below. Switch ports will automatically adjust to the characteristics (MDI/MDI-X,
speed, duplex) of the device to which is connected.
Figure 7 - PC Connect
Please refer to the
LED Indicator Specification
.The LINK/ACT/Speed LEDs for each port
lights on when the link is available.
3.4 How to Login the Switch (16 port)
As the Switch provides Web-based management login, you can configure your computer’s
IP address manually to log on to the Switch. The default settings of the Switch are shown
below.
Parameter
Default Value
Default IP address
192.168.2.1
Default user name
admin
Default password
admin
You can log on to the configuration window of the Switch through following steps:
6. Connect the Switch with the computer NIC interface.
7. Power on the Switch.
8. Check whether the IP address of the computer is within this network segment:
192.168.2.xxx (“xxx” ranges 2~254), for example, 192.168.2.100.
9. Open the browser, and enter
http://192.168.2.1
and then press “Enter”. The
Switch login window appears, as shown below.
